Программы и файлы Windows



         

Boot.ini - часть 3


Do not make this setting less than 12. Use this parameter to confirm whether a memory chip is faulty. For example, if you have a 128-megabyte (MB) system that is equipped with two 64-MB RAM modules, and you are experiencing memory-related Stop messages, you can type /maxmem=64. If the computer starts Windows and operates without problems, replace the first module to see if this action resolves the problem.

For additional information, click the following article number to view the article in the Microsoft Knowledge Base:

108393 MAXMEM option in Windows NT Boot.ini file

/noguiboot

This switch disables the bitmap that displays the progress bar for Windows startup. (The progress bar appears just before the logon prompt.)

/nodebug

This switch turns off debugging. This scenario can cause a Stop error if a program has a debug hardcoded breakpoint in its software.

/numproc=number

This switch sets the number of processors that Windows will run at startup. With this switch, you can force a multiprocessor system to use only the quantity of processors (number) that you specify. This switch can help you troubleshoot performance problems and defective CPUs.

/pcilock

For x86-based systems, this switch stops the operating system from dynamically assigning hardware input, hardware output, and interrupt request resources to Peripheral Connect Interface (PCI) devices. With this switch, the BIOS configures the devices.

/fastdetect:comnumber

This switch turns off serial and bus mouse detection in the Ntdetect.com file for the specified port. Use this switch if you have a component other than a mouse that is attached to a serial port during the startup process. For example, type /fastdetect:comnumber, where number is the number of the serial port. Ports may be separated with commas to turn off more than one port. If you use /fastdetect, and you do not specify a communications port, serial mouse detection is turned off on all communications ports.

Note In earlier versions of Windows, including Windows NT 4.0, this switch was named /noserialmice.



Содержание  Назад  Вперед